You encounter a situation where the Roewe i6 cannot be ignited and started after it is stalled. This may be caused by a variety of reasons. Here are some possible reasons and corresponding solutions, which I hope will be helpful to you.
1hollywoodcasinovideopoker. Check battery power
First, you can check whether the vehicle's battery has enough power. If the battery is low, the vehicle may not start normally. You can use a voltmeter to measure the voltage of the battery. Under normal circumstances, the battery voltage should be above 12.6V. If the voltage is too low, you can use a charger to charge the battery or replace the battery.
2. check the fuel system
Secondly, the fuel system may also prevent the vehicle from starting. You can check whether the fuel pump is working properly and whether the fuel line is blocked. If there is a problem with the fuel system, you need to contact a professional maintenance personnel for repair.
3. Check the ignition system
A faulty ignition system may also prevent the vehicle from starting. You can check whether the ignition coil, spark plug and other ignition system components are normal. If there is a problem with the ignition system, you will need to replace the appropriate components.
4. check the sensor
Some sensor failures may also prevent the vehicle from starting, such as crankshaft position sensors, camshaft position sensors, etc. You can use a diagnostic tool to read the vehicle's fault code, determine which sensor is the problem, and carry out corresponding repair or replacement.
Below is a table listing some common fault codes and their possible causeshollywoodcasinovideopoker：
Fault code Possible cause P03011 cylinder ignition coil fault P0355 crankshaft position sensor fault P0335 crankshaft position sensor circuit fault P0340 camshaft position sensor fault P0345 camshaft position sensor circuit faultIf none of the above methods can solve the problem, it is recommended that you contact Roewe 4S store or professional maintenance personnel for further inspection and maintenance.
5. Contact Roewe 4S store or professional maintenance personnel
If you are not familiar with vehicle maintenance or none of the above methods can solve the problem, it is recommended that you contact Roewe 4S shop or professional maintenance personnel for further inspection and maintenance. They have professional equipment and technology that can more accurately diagnose problems and provide effective solutions.
In short, the failure to ignite and start the Roewe i6 after stalling may be caused by a variety of reasons. You can check the battery power and fuel system yourself first, and then check the ignition system and sensors. If the problem still cannot be solved, it is recommended that you contact a professional car repair personnel for further inspection and repair.